Products

A pre-crimped 10 pin ribbon cable to connect a LCD shield to the MKS's EXP1 port.  Comes with a 10-pin Dupont cable attached so you just have to co...

A standard LCD shield suitable for Arduino Mega or MKS (with the ribbon cable)

Non-printed Hardware needed to build an OpenAstroGuider (Screws and printed Parts not included). The IMX290 comes with a 1 meter USB cable. I know ...

Ready-to-use, fully assembled OpenAstroGuider.  What is Autoguiding and why should you use it? Printed from quality PLA made in Austria. The color ...

Struggle to get the tolerances right for the OpenAstroGuider? These parts here have as perfect tolerances as its probably possible.  The focus thre...

Build it yourself! The DIY Kit includes everything you need to build your own OpenAstroTracker and get started in Astrophotography! You will need y...

Complete Kit of all the non-printed parts to build an OpenAstroTracker. Includes: Electronics: 2x NEMA17 1x MKS Gen L 2.1 2x Bigtreetech TMC2209 1...

All mechanical printed parts to build an OpenAstroTracker. Electronic enclosure and RA Ring are NOT included! The two moving DEC parts have their 6...

This RA Ring for the OpenAstroTracker is printed in a single piece and has the middle part reinforced. This reduces the error caused by joining the...

PRESALE - Available in approx. 2-3 weeks!  All screws and nuts for assembling an OpenAstroMount. Screws are either 8.8/10.9 zink plated or A2 stain...