OpenAstroTech

A pre-crimped 10 pin ribbon cable to connect a LCD shield to the MKS's EXP1 port.  Comes with a 10-pin Dupont cable attached so you just have to co...

A standard LCD shield suitable for Arduino Mega or MKS (with the ribbon cable)

OpenAstroGuider: Your Affordable Autoguider for Stunning Astrophotography Unlock the cosmos without breaking the bank with the OpenAstroGuider. Des...

Non-printed Hardware needed to build an OpenAstroGuider v3.1 Version 3.1 requires the use of the custom PCB and a USB C cable. You need the PCB reg...

All screws and nuts for assembling an OpenAstroMount. Screws are either 8.8/10.9 zink plated or A2 stainless.    4x M3x6 30x M3x10 100x M3x12 200x ...

Build it yourself! The DIY Kit includes everything you need to build your own OpenAstroTracker and get started in Astrophotography! You will need y...

Complete Kit of all the non-printed parts to build an OpenAstroTracker. If you need Threaded Inserts for the _TI version of the printed parts, add ...

All mechanical printed parts to build an OpenAstroTracker. The RA Ring is NOT included! The two moving DEC parts have their 6001 bearings press-fit...

This RA Ring for the OpenAstroTracker is printed in a single piece and has the middle part reinforced. This reduces the error caused by joining the...